CWP panel
Ford 351W Build Summary, Parts List
Ford 351W Build Summary, Parts List
#Ford #351W #Build #Summary #Parts #List
“Mark’s Muscle Car Garage”
351 Windsor Parts List:
Block – Ford 351W , 4.030 ” bore, 357 CID , (E4 block, 1986 cast date)
Crank – stock Ford 351W, (3.500″ stroke)
Cylinder heads – World Products, Windsor Senior, 053040, milled 0.030″, 60 cc chamber, CR ~ 10.5:1
Connecting rods – Scat, 25955912
Camshaft – Comp Cams,…
source
To see the full content, share this page by clicking one of the buttons below |
Maybe 480. That’s pushing it.
Did you use 'Old Ford Blue' for this paint? Is it rattle can or did you use a quart and then spray? It looks good.
Just shy of 600 hp
With that flat top piston I don’t believe a 60 cc chamber will get you a 10.5-1 CR. Especially with your piston below deck. It’s more likely between 9.5 and 10. You might want to check it.
Ansen has VC spacers in as-cast or polished at 99 bucks.
E4 indicates 1984
Easily one of the best engines Ford ever bolted into a chassis. Very underrated and at one time, overlooked. Owned mine since August 28, 1969. Bolted into my original 1969 Mach 1. Just finished rebuilding that original engine. Blew a head gasket after FIFTY-FOUR YEARS of dependable service. Running sweet again!
Awesome powerplant man.
What cc are the chambers ?
Compression ratio ?
you should be close to 500! good luck at the dyno!
500 Hp +, or bust .